Toyota Forklift Dash Symbols

  

Select your vehicle to find out what your warning lights are trying to tell you.

Toyota Forklift Dash Light Symbols Susi Susilawati Foto February 14, 2021 Nissan forklift dash symbols i have a light on my hyster forklift what does the sel pre glow yale forklift dash symbols hyster instrument panel warning lights. Process to get in in main menu and you can set the speed mode and power mode reset the hours and keep unlock the main menu:1. Press and hold buttons B and D.

Indicators are not available for this model.

Please see your vehicle's Owner's Manual for details or scroll down to see common indicators.

Below are some commonly found Toyota dashboard lights

Have the vehicle inspected by your Toyota dealer immediately.

Indicates a malfunction in:

  • ABS or
  • The Brake Assist system

Immediately stop the vehicle in a safe place and contact your Toyota dealer.

Indicates a malfunction in the vehicle’s charging system.

Indicates that cruise control system has been activated. Use cruise control to maintain a set speed without depressing the accelerator pedal.

*If equipped.

Have the vehicle inspected by your Toyota dealer immediately.

Indicates a malfunction in the EPS system.

Indicates that the headlight high beams have been switched on.

Immediately stop the vehicle in a safe place and contact your Toyota dealer.

Indicates that the engine oil pressure is too low.

Indicates low fuel level. (Amount remaining depends on vehicle; consult your Owner’s Manual for more details.)

Refuel the vehicle.

A buzzer sounds and the warning light flashes to indicate that the master warning system has detected a malfunction.

Warns the driver and/or front passenger to fasten their seat belts.

Fasten the seat belt.

If the front passenger's seat is occupied, the front passenger's seat belt also needs to be fastened to make the warning light (warning buzzer) turn off.

Vehicles with a Smart Key System:

The indicator light flashes after the ENGINE START STOP switch has been turned off to indicate that the system is operating. The indicator light stops flashing after the ENGINE START STOP switch has been turned to ACCESSORY or IGNITION ON mode to indicate that the system has been canceled.

Vehicles without a Smart Key System:

The indicator light flashes after the key has been removed from the engine switch to indicate that the system is operating. The indicator light stops flashing after the registered key has been inserted into the engine switch to indicate that the system has been canceled.

Toyota Forklift Dash Symbols

Toyota forklift dash warning lights symbols

Depending on the vehicle, a buzzer (intermittent) may sound to indicate that VSC is operating.

Have the vehicle inspected by your Toyota dealer immediately.

Indicates a malfunction in:

  • The SRS air bag system;
  • The front passenger occupant classification system; or
  • The seat belt pretensioner system

Toyota Forklift Dash Symbols Chart

When the light comes on:
Low tire inflation pressure such as

  • Natural causes
  • Flat tire

Immediately stop the vehicle in a safe place.

When the light comes on after blinking for 1 minute:

  • Malfunction in the tire pressure warning system.

Have the vehicle inspected by your Toyota dealer immediately.

To disable TRAC and/or VSC:

If the vehicle gets stuck in fresh snow or mud, TRAC and VSC may reduce power from the engine to the wheels. You may need to turn the system off to enable you to rock the vehicle in order to free it. To turn off TRAC, press the VSC OFF switch briefly. The AUTO LSD indicator will come on. The system is in TRAC OFF, AUTO LSD ON and VSC, Trailer-Sway Control ON mode. Pressing and holding the VSC OFF switch for three seconds while at a complete stop will illuminate the TRAC OFF and AUTO LSD indicators. The system is now in TRAC OFF, AUTO LSD ON and VSC, Trailer-Sway Control OFF mode.

Indicates that the right or left turn signal has been activated.

Toyota Forklift Dash Symbols Images

If the indicators flash faster than usual, check that a light bulb in the front or rear turn signal lights has not burned out.

Car Dashboard Symbols

Push and hold the switch while the vehicle is stopped to turn off TRAC and VSC.
The TRAC OFF indicator light and VSC OFF indicator light should come on. Push the switch again to turn the system back on.

Toyota Forklift Dash Light Symbols

Still have questions or concerns?
Consult your Owner's Manual.

Consult your Owners Manual or schedule a service with a nearby dealership.

Caution*

*If a safety system warning light does not come on...

Should a safety system light such as the ABS and SRS airbag warning lights not come on when you start the hybrid system, this could mean that these systems are not available to help protect you in an accident, which could result in death or serious injury. Have the vehicle inspected by your Toyota dealer immediately if this occurs.

Dashboard icons are displayed in a variety of colors, depending on the system and its status in a specific vehicle. Yellow icons indicate an item of importance (such as low fuel), but are not necessarily a warning. Red icons indicate a condition that requires immediate attention, such as an open door or low engine oil pressure. See your vehicle's Owner's Manual for more details.

Countless
reasons to join.

Create an account and get the most out of your Toyota today.